Sharp UX-1300 User Manual

Display messages
The paper size setting is incorrect. Change the
paper size setting as described in "Loading the
Paper" in Chapter 1.
COVER OPEN The printing compartment cover is open. Close it.
DOCUMENT JAM
FAX RX IN MEMORY
CHECK PAPER SIZE
The original document is jammed. See the
following section, "Clearing Paper Jams".
A fax has been received in memory because the
imaging film needs replacement, you have run
out of printing paper, or the paper is jammed.
The fax will print out automatically when the
problem is fixed.
The imaging film may need replacement. Check
FILM END the film and replace it if necessary.
FUNCTION MODE The FUNCTION key has been pressed.
Transmission or reception was not successful.
LINE ERROR Press STOP to clear the message, and then try
again.
An extension phone connected to the fax is
being used. Do not lift the fax’s handset or
LINE IS IN USE attempt transmission at this time, as this will
interrupt the conversation on the extension
phone.
MEMORY IS FULL The memory is full. See "Memory" in Chapter 7.
The fax is preparing to or printing out a
ON HOOK DIAL The SPEAKER key has been pressed and the
fax is waiting for you to dial.
OUT OF PAPER You are out of printing paper.
The print head has overheated. Operation can
OVER HEAT be continued once it cools.
The printing paper is jammed. See the following
PAPER JAMMED section, "Clearing Paper Jams".
Note: If you have turned on the Caller ID function, see "Caller ID" in Chapter 7 for
display messages related to Caller ID.
TROUBLESHOOTING 11-3

Sharp UX-1300 Specifications

General

Brand	Sharp
Model	UX-1300
Category	Fax Machine
Language	English