Sharp UX-1300 User Manual

QUICK REFERENCE GUIDE
SETTING THE DATE & TIME
To set the date and time, press the following
sequence of keys: — Funcrin
"DATE & TIME SET" will appear.
Press the START key:
Enter two digits for the Month (01 through 12).
Enter two digits for the Date (01 through 31).
Enter two digits for the Year (00 through 99).
Enter two digits for the Hour (01 through 12).
Enter two digits for the Minute (00 through 59).
Press the "¥" key for A.M. or the "#" key for
P.M.
When
finished,
press
the
START
key
and
then
the
STOP
key:
m
gies
(See Page 2-7 of your
manual.)
STORING & CLEARING NUMBERS
FOR AUTOMATIC DIALING
To store a new number or change an existing
number, press the following sequence of keys:
re.
"FAX/TEL # MODE’ will appear.
1. Press the "1" key:
2. Enter a 2-digit number (from "01" to "99")
by pressing the number keys. This will be
the Speed Dial number.
ART
3. Press the START key: | @ |
4. Enter the name of the location by pressing
number keys (max. of 20 characters).
5. Press the START key: |
6. Return to Step 3 to store another number,
or press STOP to exit.
To clear a Speed Dial number, press the fol-
lowing sequence of keys: Function
Press "2" and then enter the 2-digit Speed Dial
number.
Press:
(See Page 2-11 of your operation manual.)
SENDING DOCUMENTS
ly
Place your document
(up to 20 pages) face
down in the document
feeder.
Normal Dialing
SPEAKER
se
1. Lift the handset or press
2. Dial the fax number by pressing the num-
ber keys.
3. Wait for the reception tone (if a person an-
swers, ask them to press their Start key).
4. Press your START key and then replace
the handset.
Rapid Key Dialing
Press the appropriate Rapid Key. Transmis-
sion will begin.
Speed Dialing
1. Press the SPEED DIAL key: "Q-
2. Enter the Speed Dial number by pressing
the number keys.
3. Press: § © J
Direct Keypad Dialing
1. Enter the fax number by pressing the num-
ber keys.
$
if
(See Pages 3-1- 3-10 of your manual.)
RECORDING AN OUTGOING MES-
SAGE
The answering machine in your fax has four
boxes for recording incoming voice messages
when it is set to TAD reception mode. The ’
General Box is for general messages, and
Box 1, Box 2, and Box 3 are each for personal
messages. To leave a message in a personal
box, your caller must press the number of that
box on his or her telephone before speaking.
If a number isn’t pressed, the message will be
recorded in the General Box.
Note: To use TAD mode, you must record a
General outgoing message. To use a personal
box, you must also record an outgoing mes-
sage for that box.
Quick-ii
QUICK REFERENCE GUIDE

Sharp UX-1300 Specifications

General

Brand	Sharp
Model	UX-1300
Category	Fax Machine
Language	English