Messages and Signals
94
Messages and Signals
Display messages
Note:
If you have turned on the Caller ID function, see Caller ID in Chapter 7
for display messages related to Caller ID.
COVER OPEN The operation panel is open. Close it.
DOCUMENT JAMMED The original document is jammed. See the following
section,
Clearing Paper Jams
.
FUNCTION MODE The
FUNCTION
key has been pressed.
LINE BUSY This appears if you attempt to send a fax by
automatic dialing and the line is busy or the receiving
fax machine doesn’t answer (even after automatic
redialing). Press the
STOP
key to clear the message.
LINE ERROR Transmission or reception was not successful. Press
the
STOP
key to clear the message and then try
again. If the error persists, see
Line Error
in
Problems
and Solutions
in this chapter.
NO DATA This appears if you attempt to search for an
automatic dialling number when none have been
stored.
NO # STORED You have tried to dial or clear a Rapid Key or Speed
Dial number that hasn’t been programmed (a full
number hasn’t been assigned to it).
OFF HOOK This appears if you forgot to replace the handset after
using it to dial and send a fax. Replace the handset or
press the
STOP
key to clear the message.
ON HOOK DIAL The
SPEAKER
key has been pressed and the fax
machine is waiting for you to dial.
OUT OF PAPER You have run out of thermal paper. Load a new roll of
thermal paper as explained in
Loading the Thermal
Paper
in Chapter 1.
all-ux40.book Page 94 Thursday, November 18, 1999 2:35 PM
To Next Page
Loading...
Need help?
General
