Loading the Thermal Paper
19
1. Installation
YES
NO!
♦
Important:
The roll must be placed so that the leading edge of the
paper unrolls as shown. (The paper is only coated on one side for
printing. If the roll is placed incorrectly, the paper will come out
blank after printing.)
3
Unwrap the roll of thermal paper and
place it in the compartment.
4
Insert the leading edge of the paper
into the slot as shown. Continue to
push the paper through the slot until it
comes out the opening in the front of
the machine.
all-ux40.book Page 19 Thursday, November 18, 1999 2:35 PM
To Next Page
Loading...
Need help?
General
