Sharp UX-53

Using TEL Mode
44
Answering on an extension phone
1 Answer the extension phone when it
rings.
2 If you hear a soft fax tone, wait until your fax responds (the extension
phone will go dead), then hang up.
3 If the fax doesn't respond, or if the other party first talks to you and then
wants to send a fax, press once and twice on the extension
phone (only on a tone dial phone). This signals the fax to begin
reception. Hang up.
• The above step is necessary if you have set the Fax Signal Receive setting
(page 45) to NO.
• Your fax will not accept the signal to begin reception (5**) if a document is
loaded in its feeder.
5
Phone goes dead
Beep
all.bookPage44Monday,January23,20062:05PM