Messages and Signals
78
Messages and Signals
Display messages
Note: If you have turned on the Caller ID funciton, see Caller ID in Chapter 7
for display messeges related to Caller ID.
CHECK PAPER The thermal paper is jammed or isn’t loaded properly.
Remove and reload the paper. (See the following
section, Clearing Paper Jams.)
COVER OPEN The operation panel is open. Close it.
DOCUMENT JAMMED The original document is jammed. See the following
section, Clearing Paper Jams.
FAX RX IN MEMORY A fax has been received in memory because you
have run out of thermal paper or the paper is
jammed. The fax will print out automatically when the
problem is fixed.
FUNCTION MODE
has been pressed.
HOLD
has been pressed to put the other party on hold
during a phone conversation. Press again to
take the other party off hold.
KEY LOCK The Key Lock function has been activated to prevent
unauthorized use of the
machine (see page 64).
LINE BUSY This appears if you attempt to send a fax by
automatic dialling and the line is busy or the receiving
fax machine doesn’t answer. Press to clear the
message.
LINE ERROR Transmission or reception was not successful. Press
to clear the message and then try again. If the
error persists, see Line Error on page 73.
all.bookPage78Monday,January23,20062:05PM
To Next Page
Loading...
Need help?
General
