Sharp ViewCam VL-WD255U - Tape Playback; To Stop Playback

vii
Tape Playback
1 Press the LCD monitor OPEN release
button (1), and open the LCD monitor
to a 90° angle to the camcorder body
(2).
2 Adjust the LCD monitor to an angle that
allows easy viewing on the on-screen
picture.
To stop playback
Press d.
90
3 Set the Media Selection
switch to TAPE.
4 Hold down the Lock button
and set the Power switch to
VCR.
5 Press e (or r) on the Operation
button to rewind (or fast forward) the
tape to the desired point.
6 Press y to begin playback.
AUDIO 12
+
AUDIO 12
+
Quick Operation Guide
Easy Camera Recording on
Tape
1 Make sure that a cassette is inserted.
5 Press the REC START/STOP button to
begin recording.
2 Remove the lens cap, and lift up the
viewfinder.
3 Set the Media Selection
switch to TAPE.
4 Hold down the Lock button
and set the Power switch to
CAMERA.
Lock button
REC
Power Zoom
control
Zooming
Push the Power Zoom control to T (1)
(telephoto) or W (2 ) (wide angle) side.
LCD monitor OPEN
release button
Lock button