Shelly Wave 1 - 6.2 Removing the Device from a Z-Wave network (exclusion)

EN.
10
6. The green LED will be blinking in Mode 1 if the Device is successfully added to a Z-Wave®
network.
*Learn mode - a state that allows the Device to receive network information from the
gateway.
6.1.3 Adding (inclusion) with the S button
1. Connect the Device to a power supply.
2. Check if the blue LED is blinking in Mode 1. If so, the Device is not added to a Z-Wave®
network.
3. Enable add/remove mode on the gateway.
4. To enter the Setting mode, quickly press and hold the S button on the Device until the
LED turns solid blue.
5. Quickly release and then press and hold (> 2s) the S button on the Device until the blue
LED starts blinking in Mode 3. Releasing the S button will start the Learn mode.
6. The blue LED will be blinking in Mode 2 during the adding process.
7. The green LED will be blinking in Mode 1 if the Device is successfully added to a Z-Wave®
network.
Note! In Setting mode, the Device has a timeout of 10s before entering again into Normal mode.
6.2 Removing the Device from a Z-Wave® network (exclusion)
Note! The Device will be removed from your Z-Wave® network, but any custom configuration
parameters will not be erased.
Note! All Device outputs (O, O1, O2, etc. - depending on the Device type) will turn the load 1s
on/1s off /1s on/1s off if the Device is successfully added to/removed from a Z-Wave® network.
6.2.1 Removing (exclusion) with a switch/push-button
1. Connect the Device to a power supply.
2. Check if the green LED is blinking in Mode 1. If so, the Device is added to a Z-Wave®
network.
3. Enable add/remove mode on the gateway.
4. Toggle the switch/push-button connected to any of the SW terminals (SW, SW1, SW2,…)
3 times within 3 seconds (this procedure puts the Device in Learn mode). The Device must
receive on/off signal 3 times, which means pressing the momentary switch 3 times, or
toggling the switch on and off 3 times.
5. The blue LED will be blinking in Mode 2 during the removing process.