EN.
6
Button:
• S: S button
4.1 Installation instruction
The Device can control a various type of loads (e.g., bulbs) in one electrical circuit up to 3.5 kW
/ 240 V AC. It can be retrofitted into standard electrical wall boxes, behind power sockets and
light switches or other places with limited space.
⚠CAUTION! Danger of electrocution. Mounting/installation of the Device to the power grid has
to be performed with caution, by a qualified electrician.
⚠CAUTION! Danger of electrocution. Every change in the connections has to be done after
ensuring there is no voltage present at the Device terminals.
⚠CAUTION! Use the Device only with a power grid and appliances that comply with all
applicable regulations. A short circuit in the power grid or any appliance connected to the
Device may damage it.
⚠CAUTION! Do not connect the Device to appliances exceeding the given max. load!
⚠CAUTION! Do not shorten the antenna.
⚠CAUTION! Connect the Device only in the way shown in these instructions. Any other method
could cause damage and/or injury.
⚠CAUTION! Do not install the Device where it can get wet.
⚠CAUTION! Do not use the Device if it has been damaged!
⚠CAUTION! Do not attempt to service or repair the Device yourself!
⚠CAUTION! Use only one phase AC circuit. Do not use mixed AC and DC circuits.
⚠CAUTION! Before starting the mounting/installation of the Device, check that the breakers
are turned off and there is no voltage on their terminals. This can be done with a phase tester
or multimeter. When you are sure that there is no voltage, you can proceed to connecting the
wires.
⚠CAUTION! Do not allow children to play with the push-buttons/ switches connected to the
Device. Keep the devices for remote control of Shelly Qubino (mobile phones, tablets, PCs)
away from children.
To Next Page
Loading...
Need help?
General
