EN.
3
Parameter No. 25 - Set timer units to s or ms for O (O1) ..................................................... 19
Parameter No. 91 - Water Alarm .......................................................................................... 19
Parameter No. 92 - Smoke Alarm ......................................................................................... 19
Parameter No. 93 - CO Alarm ............................................................................................... 20
Parameter No. 94 - Heat Alarm ............................................................................................ 20
Parameter No. 120 - Factory Reset ....................................................................................... 20
Parameter No. 201 - Serial Number 1................................................................................... 21
Parameter No. 202 - Serial Number 2................................................................................... 21
Parameter No. 203 - Serial Number 3................................................................................... 22
10. Z-Wave® Command Class ...................................................................................................... 23
11. Z-Wave® Notifications Command class ................................................................................. 25
11.1 Overheat detected ............................................................................................................ 25
12. Z-Wave® Associations ............................................................................................................ 26
13. Supported load types ............................................................................................................. 27
14. Technical Specifications ......................................................................................................... 27
15. Important disclaimer ............................................................................................................. 29
16. Disposal & Recycling .............................................................................................................. 29
16.1 FCC Notes .......................................................................................................................... 29
17. Manufacturer ......................................................................................................................... 30
READ BEFORE USE
This document contains important technical and safety information about the Device, its safe
use and installation.
CAUTION! Before beginning the installation, please read carefully and entirely this guide and
any other documents accompanying the Device. Failure to follow the installation procedures
could lead to malfunction, danger to your health and life, violation of law or refusal of legal
and/or commercial guarantee (if any). Allterco Robotics EOOD is not responsible for any loss or
damage in case of incorrect installation or improper operation of this Device due to failure of
following the user and safety instructions in this guide.
To Next Page
Loading...
Need help?
General
