Shibaura ST450 - Wheel Bolt Torque; Rim to Disc Bolt Torque

 SECTION 3 – LUBRICATION AND MAINTENANCE 
3-27
WHEEL BOLT TORQUE
Tighten the wheel bolts (1) in Figure 3-44, to the
specified torque any time the wheel assembly is
removed from the tractor or the wheel bolts are
loosened.
Front Wheel Torque
175 N·m
Rear Wheel Torque
175 N·m
Check wheel bolt (2) in Figure 3-45, torque daily
until torque stabilizes.
RIM TO DISC BOLT TORQUE
Tighten the rim to disc bolts (3) in Figure 3-46, to
the specified torque
 anytime the wheel spacing
is changed or bolts have
 been loosened.
Rear Disc Torque
230 N·m
IMPORTANT: Check and tighten wheel and disc
bolts to proper torque specifications after the
following hours of use:
First 5 hours.
First 50 hours.
Every 200 hours.
Figure 3-44
Figure 3-45
Figure 3-46