99
Parameter Description
Parameter Description
5.38 Programmed Operation Mode (P.100~P.108, P.111~P.118, P.121~P.123,
P.131~P.138)
P.100 “Minute/second selection”
P.101~P.108 “Runtime of each section”
P.111~P.118 “Acceleration/deceleration time of each section”
P.121 “Run direction in each section”
P.122 “Cycle selection”
P.123 “Acceleration/deceleration time setting selection”
P.131~P.138 “Frequency of each section”
Parameter Factory Setting Setting Range Remarks
0
The running time minimum increment is 1
minute.
100 1 0, 1
1
The running time minimum increment is 1
second.
--- s0006~0 s0 801~101
0~600s When P.21=0
111~118 0s
0~6000s When P.21=1
121 0 0~225
0: Cycle function invalid;
1~8: Run circularly
--- 8~0 0 221
--- 1 ,0 0 321
--- zH056~0 0 831~131
<Setting>
1. Programmed operation mode
• The calculation methods of runtime and acceleration/deceleration time in each section are presented
in the figure below:
Related parameters
P.80~P.84, P.86
“Multi-function terminals selection ”
P.8 “Deceleration time ”
P.7 “Acceleration time ”
P.21 “Acceleration /deceleration
time increments”
To Next Page
Loading...
Need help?
General
