3 Installation Procedure Clarity Control Module
Note: Other fields from this dialog are described later in the manual ("Shimadzu
GC-17A/14C Setup" on page16).
The Shimadzu GC- 17A/14C item ② will appear in the Setup Control
Modules list of the System Configuration dialog.
Drag the GC icon from the Setup Control Modules list on the left side to
the desired Instrument tab ③ on the right side ④, or use the button ⑤
to do so.
Fig 6: System Configuration
Set the Start and Ready input and output numbers for your acquisition
card according to the wires used for synchronization.
- 6 -
To Next Page
Loading...
