Shimadzu GC17A - Method Setup - GC

To Next Page

To Previous Page

Shimadzu GC17A/GC14C 4 Using the control module

4.1.6 Method Setup - GC - Shutdown

Fig 12: Method Setup - GC Control - Shutdown

The Shutdown tab of the GC control enables to switch off the oven heater

after the analysis is finished.

Keep state - the heater remains on

Set off after Analysis - the heater will be switched off after the end of

gradient program.

Note: When any method is sent to GC, the heater will be always switched On.

Typically, the method with shutdown On will be used as the last one in a

sequence. The automatic sending of the method to the instrument should

then be disabled.

- 13 -

Shimadzu GC17A - Method Setup - GC - Shutdown