Cycle Computer Display and Setting
Changing the settings
43
3
The condition has worsened
Adjust the adjustment value by 2 speeds
in the opposite direction and check the
gear shifting operation again.
Then, adjust the value by 1 speed in the
same direction and check until any noise
or unusual feeling is gone.
− 1
1
4
Finally, go for an actual ride and check for any noise or unusual feeling.
If the adjustment value is not [0]
1
Assist Shift
Press Shift-Y or Shift-Z and revert the
adjustment value to [0].
− 4
0
2
Press Assist-X.
Select "OK", then perform an actual
gear shift to check whether the
condition has improved.
If there is any noise or unusual feeling,
see "If the adjustment value is [0]" to
continue.
Assist Shift
3
Finally, go for an actual ride and check for any noise or unusual feeling.
To Next Page
Loading...
