35
Operation of walk assist function
1.
While in walk assist mode, press and hold down Assist-Y.
•
Start the walk assist function.
•
If Assist-Y is not operated for over 1 minute, the assist
mode will change to [OFF].
•
If the switch unit is connected to EW-EN100, the LED1
blinks blue when the above operation is performed.
2.
Hold the handlebar and push the bicycle carefully.
Assist
3.
To stop the walk assist function, release Assist-Y.
4.
To exit the walk assist mode, press the Assist-X button. Assist
To Next Page
Loading...
