34
Changing the assist mode with EW-EN100
1.
Press button.
Assist mode is changed each time you press it.
The LED1 indicates current assist mode.
OFF
Lit in light blue
Lit in green
Lit in yellow
[OFF]
[ECO]
[NORM]
[HIGH]
LED1 indications Assist mode
LED1
Button
Walk assist mode
•
This mode may not be available in certain regions.
•
The walk assist function can operate at a maximum of 6 km/h. The assistance level and speed vary with the gear position.
Switch to walk assist mode
1.
Press and hold Assist-Y (about 2 seconds) until the
following occurs.
SC-E6100: [WALK] is displayed on the screen
EW-EN100: LED1 lights up blue
Assist
NOTICE
A warning tone will sound while switching is in progress if it is
not possible to switch to [WALK] mode because the current
speed is not [0 km/h] or there is pressure on the pedals etc.
< SC-E6100 >
< EW-EN100 >
LED1
Assist OFF Walk assist mode enabled
To Next Page
Loading...
