Shimano Steps EW-EN100 - Error messages on the cycle computer

57
 [RD protection reset] Reset RD protection
In order to protect the system from falls etc., if the bicycle is subjected to a strong impact, the “RD Protection function”
is enabled. The connection between the motor and the link will be momentarily severed so that the rear derailleur can
no longer operate.
Executing “RD Protection Reset” restores the connection between the motor and the link, as well as the function of the
rear derailleur.
1. Enter the [RD protection reset] menu.
(1) Launch the setting menu.
(2) Press Assist-X or Assist-Y to select [RD protection
reset], then press Assist-A or the function button.
2. Press Assist-X or Assist-Y to select [OK].
Assist
Configurable
items
Details
[OK] Execute the "RD protection reset."
[Cancel] Cancel and return to setting menu.
< SC-E7000 >
< SC-E6100 >
3. Press Assist-A or the function button.
Assist
Function button
< SC-E6100 >
< SC-E7000 >
4. Rotate the crankarm.
Connection of motor and the link is restored.