37
Clearing the traveling distance (SC-E6100)
You can clear the traveling distance in the main screen. When the traveling distance is cleared, [TIME] (travelable time),
[AVG] (average speed), [MAX] (maximum speed) are also cleared.
This operation can only be used when SW-E6010 is being used.
1.
Press Assist-A or function button to change the travel
data display to [DST].
Assist
Function button
2.
Press and hold down Assist-A or the function button
until the value below the [DST] display blinks.
Assist
Function button
3.
Press Assist-A or the function button again.
•
Travel data is cleared.
•
The [DST] value stops blinking and the screen takes
resets to the basic screen after being left alone for 5
seconds.
To Next Page
Loading...
