Cycle Computer Display and Setting
Basic screen display of the cycle computer
39
Turning the battery-powered light on or off
Assist Shift
2 seconds
When the light is set in E-tube Project, pressing
the Assist-X button for 2 seconds displays the
light setting information instead of the clock
and assist mode. The light turns on and off
each time it is displayed.
It is displayed for about 2 seconds.
When the light
is turned on
When the light
is turned off
The light turns on and off in conjunction with
the battery power.
When the battery power is off, the light is off.
Clearing the traveling distance
When the light is not connected, you can clear the traveling distance in the main screen. If a light adapter is connected and confi gured, clear the
traveling distance (DST) according to "Changing the settings"-"Clear settings (Clear)".
1
Assist Shift
2 seconds
Change the traveling data display to DST
and press the Assist-X button for 2
seconds.
2
Assist Shift
Release the button when the DST
indication starts blinking.
In this state, pressing the Assist-X button
again clears the traveling distance.
•
If you do not operate the system for fi ve
seconds, the DST indication stops blinking
and the display returns to the basic screen.
•
When the traveling distance is cleared,
TIME, AVG, and MAX are also cleared.
To Next Page
Loading...
