Shure Incorporated
26/70
•
•
•
1.
2.
Shure SB900 Runtime
1 mW 10 mW 20 mW
>9 hours >9 hours >6 hour
Important Tips for Care and Storage of Shure Rechargeable Batteries
Proper care and storage of Shure batteries results in reliable performance and ensures a long lifetime.
Always store batteries and transmitters at room temperature
Ideally, batteries should be charged to approximately 40% of capacity for long-term storage
During storage, check batteries every 6 months and recharge to 40% of capacity as needed
Installing the Battery Contact Cover
Install the included battery contact cover (65A15947) on the handheld transmitter to prevent light reflection in broadcast and
performance situations.
Align the cover as shown.
Slide the cover over the battery contacts until it is flush with the transmitter body.
Note: Slide the cover off before inserting the transmitter in the battery charger.
Setting Receiver Gain
The receiver gain control sets the audio signal level for the entire receiver and transmitter system. Changes to the gain settings
occur in realtime allowing for adjustments during live performances. When adjusting the gain, monitor the audio meter levels to
prevent signal overloads.
Receiver Gain Controls
The gain can be adjusted by using the gain ▲▼ buttons or by entering the AUDIO menu and using the control wheel.
Tip: To quickly adjust the gain, press and hold a gain button to enable accelerated scrolling.
To Next Page
