SICE S 60 - TROUBLESHOOTING; Machine Start-up Issues; Control and Movement Issues

User Manual S60 93
UK
Oil leak
Union loose
➥ Tighten the union
Pipe cracked
➥ Replace the pipe
A control remains activated
Switchbroken
➥ Clean or replace the switch
Solenoidvalvestuck
➥ Clean or replace the solenoid valve
Turntable cylinder pressure drop
Oil leakage inside the distributor
➥ Replace the distributor
Gaskets worn
➥ Replace the gaskets
Motor stops during use
Overload cut motor protector activated
➥ Open the electric system box by loosening the screws that hold the closure hooks,
thenreactivatetheoverloadcut-outbyraisingthegreybar(Ag.39).Attheend,
reclose the electric system box.
The machine does not move
Current does not arrive to the solenoid valve
➥ Check the electric connection to the solenoid valve
Solenoidvalveblocked
➥ Clean or replace the solenoid valve
Transformer fuse broken
➥ Replace the fuse
Control lever incorrectly calibrated
➥ Call the service centre
Batteriesrundown(redLEDon)(onlyintheradioversions)
➥ Charge the batteries
➥ Replace disposable batteries