2 Safety information
2.1 General safety notes
Product integration
DANGER
T
he product can not offer the expected protection if it is integrated incorrectly.
►
Plan the integration of the product in accordance with the machine requirements
(project planning).
►
Implement the integration of the product in accordance with the project planning.
Mounting and electrical installation
DANGER
D
eath or severe injury due to electrical voltage and/or an unexpected startup of the
machine
►
Make sure that the machine is (and remains) disconnected from the voltage
supply during mounting and electrical installation.
►
Make sure that the dangerous state of the machine is and remains switched off.
WARNING
Im
proper mounting or use
The target safety-related level may not be achieved in the event of non-compliance.
►
When mounting, installing, and using the Flexi Soft safety controller, remember to
observe all applicable standards and directives.
►
Observe the relevant national and international legal provisions for the installation
and use of the Flexi Soft safety controller, its commissioning, and technical inspec‐
tions repeated at regular intervals.
►
The manufacturer and operator of the machine on which the Flexi Soft safety
controller is used are responsible for liaising with the relevant authorities about all
applicable safety regulations/rules and for ensuring compliance with these.
►
The notes, in particular the test notes, in these operating instructions (e.g. regard‐
ing use, mounting, installation, or integration into the machine controller) must
always be observed.
►
The thorough checks must be carried out by qualified safety personnel or specially
qualified and authorized personnel, and must be recorded and documented by a
third party to ensure that the tests can be reconstructed and retraced at any time.
SAFETY INFORMATION 2
8012478/1IG6/2023-02-24 | SICK O P E R A T I N G I N S T R U C T I O N S | Flexi Soft Modular Safety Controller
11
Subject to change without notice
To Next Page
Loading...
