EasyManua.ls Logo

SICK Inspector85 Series - Personnel Requirements and Operational Hazards

SICK Inspector85 Series
52 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2.6 Requirements for skilled persons and operating personnel
WARNING
Risk of injury due to insufficient training.
Improper handling of the device may result in considerable personal injury and material
damage.
All work must only ever be carried out by the stipulated persons.
The following qualifications are required for various activities:
Table 2: Activities and technical requirements
Activities Qualification
Mounting, maintenance
Basic practical technical training
Knowledge of the current safety regulations in the workplace
Electrical installation,
device replacement
Practical electrical training
Knowledge of current electrical safety regulations
Knowledge of the operation and control of the devices in their
particular application
Commissioning, configura‐
tion
Basic knowledge of the computer operating system used
Basic knowledge of the design and setup of the described
connections and interfaces
Basic knowledge of data transmission
Knowledge of the configuration of image processing systems
and network components
Operation of the device for
the particular application
Knowledge of the operation and control of the devices in their
particular application
Knowledge of the software and hardware environment for the
particular application
2.7 Operational safety and specific hazards
Please observe the safety notes and the warnings listed here and in other sections
of this product documentation to reduce the possibility of risks to health and avoid
dangerous situations.
Danger due to visible radiation is product-specific. See the technical data for more
information.
CAUTION
Optical radiation: LED risk group 1, visible radiation, 400nm to 780nm
The LEDs may pose a danger to the eyes in the event of incorrect use.
Do not look into the light source intentionally.
Do not open the housing. Opening the housing will not switch off the light source.
Opening the housing may increase the level of risk.
Comply with the current national regulations on photobiological security of lamps
and lamp systems.
If the product is operated in conjunction with external illumination units, the risks
described here may be exceeded. This must be taken into consideration by users on a
case-by-case basis.
SAFETY INFORMATION 2
8028305//2023-05 | SICK O P E R A T I N G I N S T R U C T I O N S | Inspector85x
11
Subject to change without notice

Table of Contents