7.6.4 Tutorials and code samples
Tutorials and code samples for general and device-specific topics are available to help
the user get started with the programming of the device:
•
Tutorials are available from the SICK Support Portal: supportpor‐
tal.sick.com/pages/appspace/documentation-and-more.
•
Code samples are available from Gitlab: gitlab.com/sick-appspace/samples.
The above pages can be accessed directly from the Help menu in SICK AppStudio.
7.7 MicroSD memory card
MicroSD memory card
The device has a card slot for a microSD memory card integrated in the housing. The
memory card is used as an external storage medium. The microSD memory card can
also be ordered as an optional accessory. To ensure that the memory card functions
reliably, only use card types (industrial standard) approved by SICK.
Functions
Function Description
Cloning Save currently valid save parameter set on an external storage
medium. The externally stored parameter set is also updated auto‐
matically each time the parameterization is permanently saved.
The cloning function provides the means, for example in the event
of a device fault, for manual transmission of the parameter set to
an exchange unit of the same type.
Other functions are available upon request.
Further topics
•
Inserting and removing memory card
7.7.1 Inserting and removing memory card
Important information
NOTICE
Loss of configuration data
Do not remove the memory card or switch off the supply voltage while the parameter
set is being saved. Otherwise all parameters not yet saved permanently will be lost.
Prerequisites
•
The supply voltage for the product is switched off.
•
If the cover is open, the product does not fulfill any specified enclosure rating. Only
briefly open the cover. Protect the product against moisture and dust during this
time.
Approach
Inserting the memory card
1. Open the rubber cover.
2. Making sure it is in the correct position, insert the memory card into the slot until
it locks into place. When doing this, position the contacts so that they are facing to
the rear and downwards, see the card symbol on the product.
3. Close the cover again. Make sure that the cover is flush with product.
4. Switch on the supply voltage for the product.
COMMISSIONING 7
8028305//2023-05 | SICK O P E R A T I N G I N S T R U C T I O N S | Inspector85x
37
Subject to change without notice
To Next Page
Loading...