7 Commissioning
NOTE
Update the device firmware version before you start using the device. Always use the
latest version, unless there is a specific need to use an older version. Download the
latest version of the firmware from the SICK Support Portal (supportportal.sick.com)
and install it using SICK AppManager.
Inspector85x is a programmable device. To use it, the following options are available:
•
Using the default SensorApp Nova 2D with a pre-activated Quality Inspection
license (see "Default SensorApp: Nova 2D", page 35).
•
Using other SensorApps that are available for the device (see "Installing Sensor‐
Apps", page 35).
•
Programming SensorApps for the device (see "Programming the device",
page 36).
7.1
Password management
7.1.1 Password assignment
Overview
Reading the parameter settings is possible without a password. A password can be
assigned to protect the product against unauthorized changes to the settings.
Prerequisites
•
When assigning a password for the first time, ensure the connection is secure, e.g.
by using a point-to-point connection to the device.
Approach
1. Establish a connection to the product in the web browser.
2.
Select:
3. Log in with the default password servicelevel.
✓
You will be prompted to assign a new password.
4. Assign a new password.
✓
The new password is valid immediately.
5. Log in again with the newly assigned password.
7.1.2 Changing password
Approach
1. Establish a connection to the product in the web browser.
2.
Select:
3. Log in with the last assigned password.
4. Select Changing password.
5. Assign a new password.
✓
The new password is valid immediately.
7.1.3 Resetting the password
Approach
1. Establish a connection to the product in the web browser.
2.
Select:
COMMISSIONING 7
8028305//2023-05 | SICK O P E R A T I N G I N S T R U C T I O N S | Inspector85x
33
Subject to change without notice
To Next Page
Loading...