3. Select Password forgotten?.
4. Send Device key, Serial number and Part number in an e-mail to the responsible SICK
sales company or the responsible SICK service partner, see sick.com/worldwide.
5. Click Next to confirm.
✓
The window for entering a code appears.
You can get the code from the responsible SICK sales company or the responsible
SICK service partner. The code is only valid once for the reset process. You can
close the window by clicking on the x without interrupting the reset process. If you
select Cancel or enter an incorrect code several times, the current reset process is
terminated. The requested code is no longer valid. The process must be restarted.
6. Optional: close the window by clicking on x. At a later time, open the window for
entering the code via and Password forgotten?.
7. Enter the code.
8. Click Reset to confirm.
✓
The password is reset to the servicelevel default password. Parameters are not
changed.
7.2 Computer software
SICK AppManager
The SICK AppManager software can be used for the following actions:
•
Installing a SensorApp on a device.
•
Reading and changing the device’s IP address.
•
Starting, stopping or deleting an installed SensorApp.
•
Installing firmware updates.
Download SICK AppManager from www.sick.com/SICK_AppManager. To install SICK
AppManager on the computer, open the installation (.exe) file and follow the instruc‐
tions on the screen.
SICK AppStudio
The SICK AppStudio development environment is used to program the device and to
perform diagnostics in case of faults.
The use of SICK AppStudio requires a valid license. A one-year license (art no
1610199) is available from www.sick.com/SICK_AppStudio. After purchasing the
license, download the SICK AppStudio software from the SICK Support Portal, support‐
portal.sick.com.
After downloading SICK AppStudio, follow the on-screen instructions to complete the
installation.
7.3
Network communication settings
To connect to the device from a computer, make sure that the network communication
settings are correctly set up:
•
The device must be connected to the computer via Ethernet.
•
The computer must be on the same network as the device.
•
The computer must not use the same IP address as the device. The device’s
default IP is 192.168.0.1.
Editing the device's IP address
To change the device's IP address using SICK AppManager:
1. Open SICK AppManager.
✓
All connected devices on the network are listed on the Device search tab.
7 COMMISSIONING
34
O P E R A T I N G I N S T R U C T I O N S | Inspector85x 8028305//2023-05 | SICK
Subject to change without notice
To Next Page
Loading...