Pin Signal Description
15 LINE TRIGGER IN
1
24 V Line trigger input or configurable 24 V Input/Output
Default: Line trigger input
16 I/O 3
1
Encoder reset input or configurable 24 V Input/Output
Default: Encoder reset
17 I/O 4
1
Configurable 24 V Input/Output
1
Not connected for article number 1083672
Notes
•
Make sure, that at all times, the voltage at the I/O pins is lower or equal to the
voltage at the supply pins. If not, you risk to power on the camera through the I/O
pins although it is turned off (V supply = 0 V), which is strictly forbidden.
•
When using a single-channel encoder, connect it to Encoder Input A+/A- (pin 5
and 6)
Table 3: Signal levels for Power I/O connector
Signal Pins Low High Remark
24 V inputs 10, 15, 16,
17
0... 9 V 12.5... V_Supply Pulldown: 22.5
kΩ
TTL 5, 6, 11, 12 0... +0.8 V +2 V... V_Supply RC-termination,
112 Ω / 340 pF
24 V outputs 16, 17 Output type:
Push-pull.
Max output cur‐
rent: 100 mA
5 V outputs 13, 14 Output type:
Push-pull.
GigE connector
Table 4: GigE connector, 8 pin
Pin Signal
1 GETH L1+
2 GETH L1-
3 GETH L2+
4 GETH L2-
5 GETH L4+
6 GETH L4-
7 GETH L3-
8 GETH L3+
LED definitions
Table 5: LED definitions
Indicator LED Color Function
On
O
Green Power ON
ELECTRICAL INSTALLATION 6
8020774/14IM/2019-07 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
21
Subject to change without notice
To Next Page
Loading...
