7.13.1 Device control
Table 7: Device control standard SFNC selector
Selector Type Description Visibility
DeviceTemperatureSelector enum Selects the location within the device, where the tem‐
perature will be measured.
Values:
Sensor, SensorBoard, MainBoard, ZpmSoc, Zpm1,
Zpm2, Zpm3, Zpm4, Filter
Beginner
Table 8: Device control standard SFNC parameters
Parameter Type Description Visibility Access
DeviceScanType enum Scan type of the sensor of the device.
Ranger3 uses this parameter to control if 2D images
(Areascan) or 3D profiles (Linescan3D) are acquired.
Changing the DeviceScanType automatically sets the rele‐
vant device features for the selected mode. see "Device
scan type", page 26 for details.
Values:
Areascan
Linescan3d
Expert R(W)
DeviceVendorName string Name of the manufacturer of the device. Expert R
DeviceModelName string Model of the device. Expert R
DeviceVersion string Version of the device.
Used to note hardware version.
Expert R
DeviceFirmwareVersion string Version of the firmware in the device. Expert R
DeviceManufacturerInfo string Manufacturer information about the device. Expert R
DeviceSerialNumber string Device's serial number. Expert R
DeviceUserID string User-programmable device identifier. Beginner RW
DeviceSFNCVersionMajor int Major version of the Standard Features Naming Con‐
vention that was used to create the device's GenICam
XML.
Expert R
DeviceSFNCVersionMinor int Minor version of the Standard Features Naming Con‐
vention that was used to create the device's GenICam
XML.
Expert R
DeviceSFNCVersionSubMinor int Sub minor version of Standard Features Naming Con‐
vention that was used to create the device's GenICam
XML.
Expert R
DeviceTLType enum Transport Layer type of the device.
Values:
GigEVision
Expert R
DeviceTLVersionMajor int Major version of the Transport Layer of the device. Expert R
DeviceTLVersionMinor int Minor version of the Transport Layer of the device. Expert R
DeviceTLVersionSubMinor int Sub minor version of the Transport Layer of the device. Expert R
DeviceLinkThroughputLimit int Limits the maximum bandwidth of the data that will be
streamed out by the device on the selected Link.
Guru RW
DeviceLinkHeartbeatTimeout int Controls the current heartbeat timeout of the specific
link.
A high link heartbeat timeout can be useful when
debugging PC application code. The time (in ms) is the
timeout before the device returns the Access Status to
"Open" and disconnects from the current host.
Guru RW
7 CONFIGURATION
36
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/14IM/2019-07 | SICK
Subject to change without notice
To Next Page
Loading...
