8.1.6 Log and statistics tabs
Figure 30: Log and statistics tabs
At the bottom of the main window, there are three tabs where log messages and statis‐
tics are available.
Log and Device log
The Log tab contains messages from the GUI, and the Device log tab contains messages
from the device.
The system assigns each log message a level, either SEVERE, WARNING, INFO or FINE.
Figure 31: Log tab
Statistics
The Statistics tab contains network statistics, such as lost data.
Figure 32: Statistics tab
8.1.7 General information
At the bottom of the screen, the following information is shown:
•
Model of the device
•
Name of the device (DeviceUserID)
•
IP address of the device
•
MAC address of the device
•
Serial number of the device
•
Software version
•
Frame ID of the image that is currently displayed.
NOTE
The frame ID is reset each time the camera is re-started.
8.2 Using the interface
8.2.1 Connecting and getting a 2D image
Workflow step: Start
8 OPERATION
52
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/14IM/2019-07 | SICK
Subject to change without notice
To Next Page
Loading...
