Parameter Type Description Visibility Access
GevCurrentIPConfigurationDHCP bool Controls whether the DHCP IP configuration scheme is
activated on the given logical link.
The device falls back to Link Local Address in case no
DHCP response is received after several timed out
requests.
Expert RW
GevCurrentIPConfigurationLLA bool Controls whether the Link Local Address IP configura‐
tion scheme is activated on the given logical link.
Expert R
GevCurrentIPAddress int Reports the IP address for the given logical link. Expert R
GevCurrentSubnetMask int Reports the subnet mask of the given logical link. Expert R
GevCurrentDefaultGateway int Reports the default gateway IP address to be used on
the given logical link.
Expert R
GevPersistentIPAddress int Controls the Persistent IP address for this logical link. It
is only used when the device boots with the Persistent
IP configuration scheme.
Expert RW
GevPersistentSubnetMask int Controls the Persistent subnet mask associated with
the Persistent IP address on this logical link. It is only
used when the device boots with the Persistent IP con‐
figuration scheme.
Expert RW
GevPersistentDefaultGateway int Controls the persistent default gateway for this logical
link. It is only used when the device boots with the Per‐
sistent IP configuration scheme.
Expert RW
GevTimestampTickFrequency int The timestamp tick frequency in Hz. Used for time‐
stamping frames, chunks and events.
Expert R
GevDiscoveryAckDelay int Indicates the maximum randomized delay the device
will wait to acknowledge a discovery command.
Expert R
Table 35: GigEVision control custom commands
Command Description Visibility Access
GevNetworkInterfaceReconfigure Reconfigures the network interface according to the
settings made. If the settings have changed the con‐
nection will be lost to the device and it may get a new IP
address.
Expert RW
7.13.13 Firmware update
Table 36: Firmware update custom parameters
Parameter Type Description Visibility Access
FirmwareUpdateProgress enum The current state of the firmware update process. Guru R
FirmwareUpdateScriptProgress float Estimated progress of update script. 0.00 means not
started, 1.00 means finished.
Guru R
FirmwareUpdateScriptRemaining‐
Time
int Estimated time left of the firmware update script. Guru R
CONFIGURATION 7
8020774/14IM/2019-07 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
45
Subject to change without notice
To Next Page
Loading...
