Command Description Visibility Access
TestPayloadFormatMode This feature allows setting a device in test mode and to
output a specific payload formatting for validation of
data streaming.
Guru R
TestPayloadType This feature selects the payload type the device will use
for streaming when the TestPayloadFormatMode fea‐
ture is active.
Guru R
7.13.12 Transport layer control
Normally, the user must not edit these features. Changing them can cause errors.
Table 33: Transport layer control standard SFNC parameters
Parameter Type Description Visibility Access
PayloadSize int Provides the number of bytes transferred for each
image or chunk on the stream channel.
Expert R
7.13.12.1 GigEVision
Normally, the user do not edit these parameters. Changing them can cause errors.
Table 34: GigEVision control standard SFNC parameters
Parameter Type Description Visibility Access
GevMCPHostPort int Controls the port to which the device must send mes‐
sages.
Guru R
GevMCDA int Controls the destination IP address for the message
channel.
Guru R
GevMCTT int Provides the transmission timeout value in millisec‐
onds.
Guru R
GevMCRC int Controls the number of retransmissions allowed when
a message channel message times out.
Guru R
GevMC SP int Indicates the source port for the message channel. Guru R
GevSCPHostPort int Controls the port of the selected channel to which a
GVSP transmitter must send data stream or the port
fromwhich a GVSP receiver may receive data stream.
Guru R
GevSCPSPacketSize int Specifies the stream packet size, in bytes, to send on
the selected channel for a GVSPtransmitter (set by
negotiation between the device and PC during connec‐
tion) or specifies the maximum packet size supported
by a GVSP receiver.
Expert R
GevSCPD int Controls the delay (in GEV timestamp counter unit) to
insert between each packet for this stream channel.
This feature can be used as a crude flow-control mech‐
anism if the application or the network infrastructure
cannot keep up with the packets coming from the
device.
Expert RW
GevSCDA int Controls the destination IP address of the selected
stream channel to which a GVSP transmitter must send
data stream or the destination IP address from which a
GVSP receiver may receive data stream.
Guru R
GevSCSP int Indicates the source port of the stream channel. Guru R
MultiPartSupport bool Manual Enable/Disable of multipart-configuration bit
(25) in SCCFGx register for testing.
Guru RW
GevMACAddress int MAC address of the logical link. Expert R
GevCurrentIPConfigurationPersis‐
tent IP
bool Controls whether the PersistentIP configuration scheme
is activated on the given logical link.
Expert R
7 CONFIGURATION
44
O P E R A T I N G I N S T R U C T I O N S | Ranger3 8020774/14IM/2019-07 | SICK
Subject to change without notice
To Next Page
Loading...
