Figure 24: Workflow step Start
Cameras
In this step, you search the network and see a list of all devices that are available. You
can select a device and connect or disconnect to it.
It is also possible to reconfigure the camera IP settings. This is useful for example when
you want to connect to a camera that is not on the same subnet as the NIC, see "Rec‐
ommended network card settings", page 83. Then you have to reconfigure the cam‐
era to the same subnet, before you can connect to it.
Figure 25: Workflow step Cameras
Image
Here you view the 2D image data. This is what the camera sees when it is used as an
ordinary camera.
OPERATION 8
8020774/14IM/2019-07 | SICK O P E R A T I N G I N S T R U C T I O N S | Ranger3
49
Subject to change without notice
To Next Page
Loading...
