Chapter 3 Technical Information
RFID write/read device RFH630 (HF)
24 © SICK AG · Germany · All rights reserved · Subject to change without notice 8014957/YSU6/2016-01-08
Electrical installation
Important Thanks to the CMC600 parameter memory module in combination with the CDB620-001
connection module, the two additional switching inputs "External input 1" and "External in-
put 2" on the terminals in the connection module are available as an expansion.
The inputs are wired using the connection module; for more on this, see:
Chapter 3.7.6 Wiring the "Sensor 1" switching input in the CDB620-001 connection
module, Page 31
Chapter 3.7.7 Wiring the "Sensor 2" switching input in the CDB620-001 connection
module, Page 32
Chapter 3.7.8 Wiring the "External input 1" switching input in the CDB620-001 con-
nection module, Page 33
Chapter 3.7.9 Wiring the "External input 2" switching input in the CDB620-001 con-
nection module, Page 34
3.6.7 Wiring the switching outputs
The two switching outputs "Output 1" and "Output 2" of the RFH630 can be allocated inde-
pendently of each other with various functions for the output of the result status. If the allo-
cated event occurs in the read process, then the corresponding switching output is live after
the end of the clock reading pulse for the selected pulse duration.
They are available both at the connecting cable with a 15-pin D-Sub HD male connector and
when the cable end is open.
Important Thanks to the CMC600 parameter memory module in combination with the CDB620-001
connection module, the two additional switching outputs "External output 1" and "External
output 2" on the terminals in the connection module are available.
Important Capacitive loads on the switching outputs have an effect on the switch-on and switch-off
behavior. The maximum capacity of 100 nF is a limit value.
The outputs are wired using the connection module; for more on this, see:
Chapter 3.7.10 Wiring the "Result 1" switching output in the CDB620-001 connection
module, Page 35
Chapter 3.7.11 Wiring the "Result 2" switching output in the CDB620-001 connection
module, Page 36
Chapter 3.7.12 Wiring the "External output 1" switching output in the CDB620-001
connection module, Page 37
Chapter 3.7.13 Wiring the "External output 2" switching output in the CDB620-001
connection module, Page 38
To Next Page
Loading...
