Siemens 340 - Mounting the devices on a standard mounting rail

Mounting
5.4 Mounting the devices on a standard mounting rail
SIRIUS 3RM1 motor starter
74 Manual, 11/2013, A5E0345285095020A/RS-AB/002
5.4
Mounting the devices on a standard mounting rail
Requirements
● At the installation location, a horizontal 35 mm mounting rail in accordance with
DIN EN 60715 is properly secured
● Please observe the information about the mounting position in chapter "Mounting position
(Page 56)"
Procedure
Step
Operating instruction
Figure
1 Hang the back of the device onto the upper
edge of the standard mounting rail
2 Press the lower half of the device against the
rail until the device engages