6+
)NSTALLATION INSTRUCTIONS
6
#
' #
-ARSHALLING OF THE COMMAND TRIP RELAYS ADDRESS BLOCK
4HE UNIT CONTAINS TRIP RELAYS WHICH ARE DESIGNATED
42)0 2%,!9 AND 42)0 2%,!9 4HE TRIP RELAYS CAN
BE MARSHALLED IN THE ADDRESS BLOCK 4HE BLOCK IS
REACHED BY PAGING IN BLOCKS WITH ÅÇ OR BY DIRECTLY
ADDRESSING WITH $! INPUT OF THE ADDRESS NUMBER
AND PRESSING THE ENTER KEY % 4HE SELECTION
PROCEDURE IS CARRIED OUT AS DESCRIBED IN 3ECTION
-ULTIPLE COMMANDS ARE POSSIBLE IE ONE LOG
ICAL COMMAND FUNCTION CAN BE GIVEN TO SEVERAL TRIP
RELAYS SEE ALSO 3ECTION
0RINCIPALLY ALL ANNUNCIATION FUNCTIONS IN ACCORDANCE
WITH 4ABLE CAN BE MARSHALLED TO OUTPUT COM
MAND RELAYS
4HE ASSIGNMENT OF THE TRIP RELAYS AS DELIVERED FROM
FACTORY IS SHOWN IN THE GENERAL DIAGRAMS IN !PPEN
DIX ! 4HE FOLLOWING BOXES SHOW AN EXAMPLE FOR MAR
SHALLING OF TRIP RELAY 4ABLE SHOWS ALL TRIP RELAYS
AS PRESET FROM THE FACTORY
-!23(!,,).'
42)0 2%,!93
"EGINNING OF THE BLOCK
-ARSHALLING OF THE TRIP RE
LAYS
4HE FIRST TRIP RELAY IS REACHED WITH THE KEY !
42)0
2%,!9
!LLOCATIONS FOR TRIP RELAY
#HANGE OVER TO THE SELECTION LEVEL WITH & !
42)0 2%,
NOT ALLOCATED
42)0 2%,
!2 #LOSE #MD
4RIP RELAY HAS BEEN PRESET FOR
#LOSE COMMAND FROM AUTO
RECLOSE FUNCTION &.O
NO FURTHER FUNCTIONS ARE PRESET FOR TRIP RELAY
,EAVE THE SELECTION LEVEL WITH KEY COMBINATION & ! 9OU CAN GO THEN TO THE NEXT TRIP RELAY WITH THE ARROW KEY !
42)0
2%,!9
!LLOCATIONS FOR TRIP RELAY
42)0 2%,!93
2%,!9
!2 #LOSE #MD
2%,!9
P 4RIP 0ERM
-!23(!,,).'
42)0
42)0 2%,
42)0
42)0 2%,
ST DISPLAY LINE!DDR ND DISPLAY LINE &.O
2EMARKS
(EADING OF THE ADDRESS BLOCK
2ECLOSE COMMAND FROM AUTO
RECLOSE FUNC
TION
2!2 FUNCTION IS READY TO PERMIT SINGLE
POLE
TRIP NO THREE
POLE COUPLING
4ABLE 0RESET COMMAND FUNCTIONS FOR TRIP RELAYS
To Next Page
Loading...
