Siemens 7VK512

/PERATING INSTRUCTIONS6+
6
#
' #

 39.-!.#,
/.
/&&
3YNCHRONISM AND VOLTAGE CHECK BEFORE MANUAL CLOSE
COMMAND IS
/. SWITCHED ON
/&& SWITCHED OFF
,IMIT VALUE F FOR SYNCHRONOUS MANUAL CLOSURE
3MALLEST SETTING VALUE
,ARGEST SETTING VALUE
AND 0 NO ASYNCHRONOUS MANUAL SWITCHING
 -# $F39.
(Z
 (Z
 (Z
0
 -#
39.#(2
9%3
./
3YNCHRO
CHECK BEFORE MANUAL CLOSURE
9%3
./
 -#
55
./
9%3
$EAD
BUS CHECK BEFORE MANUAL CLOSURE
./
9%3
 -#
55
./
9%3
$EAD
LINE CHECK BEFORE MANUAL CLOSURE
./
9%3
 -#
55
./
9%3
$EAD
LINE AND DEAD BUS CHECK BEFORE MANUAL CLO
SURE
./
9%3
 -#
/2)$%
./
9%3
/VERRIDE OF ANY CHECK BEFORE MANUAL CLOSURE
./
9%3
&INALLY ADDRESS  DETERMINES THE TIME PERIOD
BEGINNING FROM THE MEASURING REQUEST WITHIN WHICH
THE CHECK CONDITIONS AS PARAMETERIZED MUST BE FUL
FILLED 4HIS TIME IS VALID FOR AUTOMATIC RECLOSURE AS
WELL AS FOR MANUAL CLOSURE 7HEN THE CONDITIONS ARE
NOT FULFILLED WITHIN THIS TIME CLOSING IS BLOCKED /NLY
AFTER A RENEWED MEASURING REQUEST THE TIME STARTS
AGAIN AND A NEW CHECK IS CARRIED OUT
3UPERVISION TIME PERIOD WITHIN WHICH THE CHECK CONDI
TIONS MUST BE FULFILLED
3MALLEST SETTING VALUE
,ARGEST SETTING VALUE
 4 39.3506
 S
 S
 S