Siemens 7VK512

/PERATING INSTRUCTIONS6+
6
#
' #

 !#4)6 0!2!-
3%4 !
!DDRESS  SHOWS THE ACTUALLY ACTIVE PARAMETER SET
3%4 #
3%4 $
 !#4)6!4)/.
3%4 !
3%4 "
5SE THE
.O KEY . TO PAGE THROUGH THE ALTERNATIVE
POSSIBILITIES 4HE DESIRED POSSIBILITY IS SELECTED BY
PRESSING THE ENTER KEY %
)F YOU SELECT 3%4 "9 ").).054 THEN THE PARAMETER
SET CAN BE CHANGED
OVER VIA BINARY INPUTS SEE 3EC
TION 
3%4 "9 ").).054
 #HANGE OVER OF THE ACTIVE PARAMETER
SET VIA BINARY INPUTS
)F CHANGE
OVER OF PARAMETER SETS IS INTENDED TO BE
CARRIED OUT VIA BINARY INPUTS THE FOLLOWING IS TO BE
HEEDED
,OCALLY IE FROM THE OPERATOR PANEL OR FROM 0# VIA
THE OPERATING INTERFACE !#4)6!4)/. MUST BE
SWITCHED TO 3%4 "9 ").).054 REFER TO 3ECTION

 LOGICAL BINARY INPUTS ARE AVAILABLE FOR CONTROL OF
THE  PARAMETER SETS 4HESE BINARY INPUTS ARE
DESIGNATED
0ARAM3ELEC AND 0ARAM
3ELEC

4HE LOGICAL BINARY INPUTS MUST BE ALLOCATED TO 
PHYSICAL INPUT MODULES REFER TO 3ECTION  IN
ORDER TO ALLOW CONTROL !N INPUT IS TREATED AS NOT
ENERGIZED WHEN IT IS NOT ASSIGNED TO ANY PHYSICAL
INPUT
4HE CONTROL INPUT SIGNALS MUST BE CONTINUOUSLY
PRESENT AS LONG AS THE SELECTED PARAMETER SET
SHALL BE ACTIVE
4HE ACTIVE PARAMETER SETS ARE ASSIGNED TO THE LOGICAL
BINARY INPUTS AS SHOWN IN 4ABLE 
! SIMPLIFIED CONNECTION EXAMPLE IS SHOWN IN &IGURE
 /F COURSE THE BINARY INPUTS MUST BE DECLARED IN
NORMALLY OPEN 
./  MODE
NO
YES
NO
YES
3ET !
3ET "
3ET #
3ET $
NO
NO
YES
YES
0ARAM3ELEC0ARAM3ELEC
CAUSES
ACTIVE SET
"INARY INPUT
NO  INPUT NOT ENERGIZED
YES  INPUT ENERGIZED
4ABLE  0ARAMETER SELECTION VIA BINARY INPUT
PARAM SET
!
"
#
$
!
"
#
$
"INARY INPUT
0ARAM3ELEC
"INARY INPUT
0ARAM3ELEC
,

,

,
,
3ELECTOR SWITCH FOR
&IGURE  #ONNECTION SCHEME FOR PARAMETER
CHANGE
OVER VIA BINARY INPUTS