96
Siemens Graphical User Interface UI400 CE1U2348en
Building Technologies 2014-06-03
Manual operation
When manual operation is active, the relays are no longer switched according to
the control state, but are set to a predefined manual operation state depending on
their function.
w Navigation to special operation menu is described in Section "Operate special
functions [➙ 66]".
1. Select "Manual mode" = "On".
The function is activated. The additional operating line "Setpoint manual mode"
is displayed.
2. Conclude the function with "Manual mode" = "Off".
Floor curing function
The floor curing function is used to dry floors in a controlled manner. It can execute
a temperature profile or a fixed manual temperature can also be set.
w Navigation to special operation menu is described in Section "Operate special
functions [➙ 66]".
1. Select "Floor curing function" = [Temperature profile].
The additional Info line "Present floor curing setpoint"" and " Days
fulfilled.current" are displayed.
2. Conclude the function with "Floor curing function" = "Off".
1. Select "Floor curing function" = "Manual".
The additional Info line "Present floor curing setpoint"" is displayed.
2. Enter the "Present floor curing setpoint".
3. Conclude the function with "Floor curing function" = "Off".
Procedure
Procedure [Temperature
profile]
Procedure "Manual"
To Next Page
Loading...
Need help?
General
