41
Siemens Graphical User Interface UI400 CE1U2348en
Building Technologies 2014-06-03
5 Plant operation, quick access
"Plant operation, quick access" is done in the end user view.
You can conduct the operating steps described below on a room unit QAA74 or
operator unit AVS74. Differences between the information provided on the operator
unit and room unit are limited to the following areas:
l The room unit's start page (
) presents the values relevant to the room.
l The operator unit's start page (
) focuses on producer information.
l In the event of multiple room units, individual room units can be assigned to
individual living zones. Operator units are normally assigned to all living zones.
available in Section "Settings in detail [➙ 88]".
Basic navigation on the navigation bar and work area for the following menus is
described in Section "Operation [➙ 36]", section "Navigate and set with the control
knob".
Basic navigation
To Next Page
Loading...
Need help?
General
