Siemens ET 200S - Page 149

Commissioning and Diagnostics
6-25
Distributed I/O System ET 200S
EWA 4NEB 780 6024-02 07
Triggering of an Insert/Remove-Module Interrupt
Insert/remove-module interrupts are supported in DPV1 operation. The CPU
interrupts processing of the user program and processes the diagnostic block
OB83 instead. The result that led to the triggering of the interrupt is entered in the
start information of OB83.
6.6 Diagnostics Using STEP 5 and STEP 7
Section Description Page
6.6.1 Reading Out the Diagnosis 6-26
6.6.2 Structure of the Slave Diagnosis 6-29
6.6.3 Station Statuses 1 to 3 6-31
6.6.4 Master PROFIBUS Address 6-33
6.6.5 Manufacturer ID 6-33
6.6.6 Module Diagnosis 6-34
6.6.7 Module Status 6-35
6.6.8 Channel-Specific Diagnosis 6-38
6.6.9 Interrupts 6-48
6.6.10 Diagnostics in the Case of Invalid ET 200S Configuration States 6-55
Slave Diagnosis
The slave diagnosis complies with IEC 61784-1:2002 Ed1 CP 3/1. Depending on
the DP master, it can be read out with STEP 5 or STEP 7 for all DP slaves that
comply with the standard.
The reading out and structure of the slave diagnosis is described in the following
sections.