CHAPTER 3 | PMI OPERATION MANUAL
MAINTENANCE MODE 3-3
Control - Time / Date Touch the Time/Date box to change the time and/or date. Use the keyboard screen to
select the correct digits as the cursor moves along. The time is set according to the
24-hour clock. To advance forward without changing a digit, press >. To go backward
without changing a digit, press<. When the time and date are correct, press the Done
soft key. Refer to Figure 3-3.
Enter Time/Date: 14:41:01 07/11/02
Cancel Done
A
F
K
P
U
Z
B
G
L
Q
V
*
C
H
M
R
W
#
D
I
N
S
X
Bksp
E
Del
J
O
T
Y
Clr
0
2
4
6
8
1
3
5
7
9
CAPS
<
>
Figure 3-3
Enter Time / Date Screen
Control - Disarm / Arm Use Control Disarm/Arm to disarm or arm the operation of any of the following:
Device
Inputs (Components*)
Smoke/Photo Switch 1
Thermal Switch 2
Neural
Outputs (Components*)
Relay 1 LED
Relay 2 Status LED
*A trouble is reported for each disarmed component.
When a device or its input components are disarmed, they do not report events or
effect output logic. The output components are not controlled by output logic.
When a device or its output components are energized, they are activated and turned
on. When a device or its output components are de-energized, they are de-activated
and turned off.
Control-Disarm/Arm must not be used to silence alarm-sounding appliances.
Technical Manuals Online! - http://www.tech-man.com
To Next Page
Loading...
Need help?
General
