Siemens FLENDER H SH Series - Output Designs; Housing

27 / 96
BA 5030 en 02/2013
5.2 Output designs
..S. ..V. ..F. ..H. ..D. ..K.
Solid shaft Solid shaft Flanged shaft Hollow shaft Hollow shaft Hhollow shaft
reinforced with for with internal
parallel keyway shrink disk spline to DIN 5480
Fig. 9: Output designs
5.3 Housing
The housing is of cast iron; if required, they may also be of steel.
Housings up to size 12 are made in one part. An exception is type H1SH, which has a twopart housing
similar to those of sizes 13 to 22 of other types. The housing is rigid in design and due to its form has
excellent noise and temperature characteristics.
The gearunit housing comes with the following equipment:
• Lifting eyes (adequately dimensioned for transport)
• Inspection and/or assembly cover (for oil filling and/or inspection)
• Oilsight glass or oil dipstick (to check the oil level)
• Oildrain plug (for oil drain)
• Air filter (for venting)
Colour codes for ventilating, oil inlet, oil level and oil drainage:
Airrelief point: yellow
Oildraining point: white
Oilfilling point: yellow Lubrication point: red
Oil level: red Oil level: red