Siemens FLENDER H SH Series - Interior­preservation Procedure; Exterior Preservation; Exterior­preservation Procedure

80 / 96
BA 5030 en 02/2013
7.3.1.3 Interiorpreservation procedure
• Stop the gear unit.
• Drain oil into a suitable container (see section 10, "Maintenance and Repair").
• Unscrew the air filter including the reducing screw.
• Pour in the preservative agent through the hole of the reducing screw up to the top mark on the oilsight
glass.
For preservative agent see table 9 or 10 in item 4.4.1!
• Screw in the air filter including reducing screw.
• Start the gear unit and allow it to idle briefly.
• Unscrew the oildrain plug.
• Drain preservative agent into a suitable container.
• Dispose of preservative agent in accordance with regulations.
There is a risk of scalding from the hot preservative agent draining from the gear unit.
Wear protective gloves!
• Screw in the oildrain plug.
• Replace air filter with screw plug.
Before restarting the gear unit, replace the screw plug with the air filter. Observe the
instructions in item 7.1.1.
Gear unit with auxiliary drive:
For interior preservation works on the auxiliary drive the special operating instructions should
be observed.
7.3.2 Exterior preservation
7.3.2.1 Exteriorpreservation procedure
• Clean the surfaces.
For separation between the sealing lip of the shaftsealing ring and the preservative agent, the
shaft should be brushed with grease in way of the sealing lip.
• Apply preservative agent.
For preservative agent see table 11 in item 4.4.2!