Siemens FLENDER PLANUREX 2 PBUC Series - Re­fitting the Shrink Disk; Inspection of the Shrink Disk; Shrink Disk Type HYD (HYD = Hydraulic); Fitting

29 / 55
BA 9213 en 03/2012
Table 7: Recommended lubricants for shrink disks after their cleaning
1)
Lubricant Form Manufacturer
Molykote G Rapid Spray or paste DOW Corning
Aemasol MO 19 P Spray or paste A. C. Matthes
Unimoly P 5 Powder Klüber Lubrication
gleitmo 100 Spray or paste Fuchs Lubritec
1)
Other lubricants may be used if they have the same characteristics.
• Join inner ring (3) and outer ring (4).
• Place the tensioning bolts and screw in some threads by your fingers.
Observe the manufacturer’s instructions for handling lubricants!
Fitting and startup must be carried out by properly trained specialist personnel.
6.5.4 Refitting the shrink disk
For refittingthe shrink disk the procedure described in item 6.5.1 must be adhered to.
6.5.5 Inspection of the shrink disk
In all cases the inspection relating to the shrink disk should be carried out simultaneously with
the examination of the gear unit, however at least every 12 months.
Inspection of the shrink disk is limited to a visual assessment of its condition. The following must be
observed when carring out this work:
─ loose screws
─ damage caused by force
─ flush position of the inner ring (3) in relation to outer ring (4)
6.6 Shrink disk type HYD (HYD = hydraulic)
6.6.1 Fitting
The shrink disk is delivered ready for installation.
The shrink disk must not be dismantled before mounting for the first time.
Mounting and startup must be carried out by properly trained specialist personnel.
Prior to startup these instructions must be read, understood and adhered to. We
accept no liability for personal injury or damage due to nonobservance.
The bore of the hollow shaft and the machine shaft must be absolutely free of grease
in the area of the shrink disk seat.
This is essential for safe and reliable torque transmission.
Do not use contaminated solvents or dirty cloths for removing grease.