Siemens FLENDER PLANUREX 2 PBUC Series User Manual

6 / 55
BA 9213 en 03/2012
6. Fitting 24.............................................................
6.1 General information on fitting 24.........................................................
6.2 Unpacking 25.........................................................................
6.3 Foundation 25.........................................................................
6.4 Description of installation work 25........................................................
6.5 Shrink disk, mechanical version 26.......................................................
6.5.1 Fitting the shrink disk 26................................................................
6.5.2 Demounting the shrink disk 28...........................................................
6.5.3 Cleaning and greasing the shrink disk 28..................................................
6.5.4 Refitting the shrink disk 29..............................................................
6.5.5 Inspection of the shrink disk 29..........................................................
6.6 Shrink disk type HYD (HYD = hydraulic) 29................................................
6.6.1 Fitting 29.............................................................................
6.6.2 Demounting the type HYD shrink disk 31..................................................
6.6.2.1 Cleaning and greasing the type HYD shrink disk 31.........................................
6.7 Installation of the torque arm 31..........................................................
6.8 Gear unit with motordriven oil pump 31...................................................
6.9 Fitting of the brake and the couplings 32..................................................
6.9.1 Fitting the brake 32....................................................................
6.9.2 Fitting the couplings 32.................................................................
6.10 Onesided torque arm 32...............................................................
6.11 Final work 33..........................................................................
6.12 Screwconnection classes, tightening torques and initial-tensioning forces 33..................
6.12.1 Screwconnection classes 33............................................................
6.12.2 Tightening torques and initial-tensioning forces 34..........................................
7. Startup 36...........................................................
7.1 Procedure before startup 36............................................................
7.1.1 Removal of preservative agent 36........................................................
7.2 Filling with lubricant 37.................................................................
7.3 Startup 37...........................................................................
7.4 Removal from service 38...............................................................
7.4.1 Interior preservation during longer disuse 38...............................................
7.4.1.1 Interior preservation with gear oil 38......................................................
7.4.1.2 Interior preservation with preservative agent 38............................................
7.4.1.3 Interiorpreservation procedure 38.......................................................
7.4.2 Exterior preservation 39................................................................
7.4.2.1 Exteriorpreservation procedure 39.......................................................
8. Operation 39.........................................................
8.1 Heating element 39....................................................................
8.2 Oiltemperature measurement 39........................................................
8.3 Check 40.............................................................................
8.4 Auxiliary drive (optional) 40..............................................................
8.4.1 Avoidance of excessive speeds 40.......................................................
8.4.2 Starting with auxiliary drive 41...........................................................
8.4.3 Positioning 41.........................................................................
9. Faults, causes and remedy 42.........................................
9.1 General information on faults and malfunctions 42..........................................
9.2 Possible faults 42......................................................................

Siemens FLENDER PLANUREX 2 PBUC Series Specifications

General

Brand	Siemens
Model	FLENDER PLANUREX 2 PBUC Series
Category	Industrial Equipment
Language	English