Installation
3-14 HiPath1120, Installation Guide
Select the location for installing the equipment
Table 3-1 HiPath 1100 - Equipment installation procedures
3.3 Select the location for installing the equipment
Installation Location
The system’s installation site has been previously selected and agreed to by the client.
The following precautions must be taken:
● Do not expose the equipment to any external heat source (e.g., sunlight, heaters, etc.)
● Do not expose the equipment to excess dust
● Do not install the equipment in areas where there is a risk of condensation when the
equipment is in use. If condensation occurs, dry the equipment before starting operation.
● Do not install inside closets.
● The power outlet for connecting the system’s power supply must be located close to the
equipment and must be easily accessible.
● Follow all environmental guidelines described in the chapter “System Data“.
● Do not install in vibrating walls.
7. “Connections to the System” 3-29
8. “Installing a USB Interface” 3-31
9. “Installing an external Audio Source” 3-32
10. “Installing a TFE - entrance telephone interface” 3-32
11. “Installing telephone terminals” 3-33
12. “Performing a visual inspection” 3-35
Caution
Always use an anti-static wrist band when working with the HiPath 1100 systems
(particularly when handling the modules). Make sure the wrist band is grounded.
Warning
When using the RSA version, extension lines with a C/D interface must only be in-
stalled indoors. Only regular extensions (without a C/D interface) can be installed
outdoors.
Step Installation procedures (Information)
!
!
To Next Page
Loading...
