Installation
3-18 HiPath1120, Installation Guide
Installing modules
To help you configure the systems, we suggest that you use the Service Manual, the HiPath
1100 Manager, in off-line mode, to obtain a visual illustration of the module locations and
external lines and the resulting numbering plan (see Help - Advanced Configuration/PABX
Information for further information).
3.7.2 Location of the modules
Installation information
The MB and the modules in the HiPath 1120 system are interconnected with a flatcable (they
must be passed through the ferrite provided) and/or a pin bar.
Figure 3-5 Location of modules on HiPath 1120
Warning
Insert modules only when the power supply is turned OFF.
!
To Next Page
Loading...
