HiPath1120, Installation Guide
3-31
Installation
Installing a USB Interface
3.10 Installing a USB Interface
Introduction
To connect a PC to the HiPath 1100 using a USB interface you must have a USB adapter cable.
This interface allows you to use certain applications developed specifically for configuring and
managing user features.
3.10.1 On the HiPath 1120
Figure 3-15 Illustration of USB cable connection
Connections
Step Procedure
1. Plug the USB adapter cable (with the male Mini DIN Connector) into the 4-pin Mini
DIN Connector on the motherboard (Figure 3-15).
2. Connect the A to B Standard end of the USB cable to the USB adapter, and connect
the other end to the computer or modem.
3. See System Programming Mode in the Service Manual.
To Next Page
Loading...
