Installation
3-24 HiPath1120, Installation Guide
Installing modules
3.7.8 Installing a ISDN / S
0
module
Installation Procedures
Assembly Diagram
Figure 3-10 HiPath 1120 S
0
module
Step Procedure
1. Turn off the power supply.
2. Remove the system’s cover
3. Attach the module to the corresponding Connector on the MB
4. Reassemble the entire set.
5. “Performing a visual inspection” on page 3-35.
6. Turn on the power supply.
7. Configure the required data (see Service Manual).
X1 Connection to the MB through a pin Connector
X2 Port 1 - RJ 45
X3 Port 2 - RJ 45
To Next Page
Loading...
